Fixture Settings; Fixure Information - Prolights Tribe SUNRISE4 User Manual

12

3.13 FIXTURE SETTINGS

It is possible to change the parameter value in the following way:
Dimmer
• Enter in Dimmer mode to select specific dimming curve, press the button MENU so many times
until shows Dimmer Mode, and press the button ENTER to confirm.
• Press the button UP/DOWN to select Off - Dimmer 1 - Dimmer 2 - Dimmer 3.
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
Back Light
• To activate Backlight display press the button MENU so many times until shows Back Light, and press
the button ENTER to confirm.
• Press the button UP/DOWN to select On - 10S - 20S - 30S.
• Press ENTER button to confirm the selection.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically.
Fan Mode
• To set the Fan Mode press the button MENU so many times until shows Fan Mode, and press the but-
ton ENTER to confirm.
• Press the button UP/DOWN to select Auto - High.
• Press ENTER button to confirm the selection.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically.
LED Frequency
• To adjust the frequency of the LEDs, press the MENU button repeatedly until the display shows LED
Frequency, and then press the ENTER button.
• Select the frequency (600 Hz - 25 KHz) using the UP/DOWN buttons.
• To confirm, press the ENTER key.
• Press the MENU button to go back or wait a few seconds to exit the setup menu.
3.14 FIXTURE INFORMATION
Auto Test
Allow checking the proper functioning of the unit. Start the automatic test in the following way:
• Press the button MENU so many times until shows Information, then press the ENTER button to con-
firm.
• Using the button UP/DOWN to select Auto.
• To confirm and start the automatic test press the ENTER button.
Fixture Hours
Show the fixture working hours.
• Press the button MENU so many times until shows Information. Press the button ENTER to confirm
• Using the button UP/DOWN to select Fixture Hours, then press the button ENTER to confirm
• Then the display will show the working hours.
SUNRISE4