Download Print this page

Adjusting The Backrest - Childcare Epix 015710 Manual

Advertisement

Assembly / Operating Instructions

Adjusting the backrest

This stroller has an adjustable backrest. The upright position on the
backrest is not suitable for use with children less than six months old.
For use with a newborn (0-6mths), the seat should be fully reclined.
The backrest should only be adjusted to a more upright position
as the child grows older and is able to support their head without
assistance.
1.
To operate the backrest; pull backrest adjusting lever upwards
and push up to 1 of 3 desired positions. Release lever once
satisfied with position.
CAUTION: Do not adjust the backrest while child is in the stroller.
To extend canopy
1.
To extend the canopy, pull forward.
2.
To close the canopy, pull back.
CAUTION: The canopy must be fully closed before folding the
stroller.
10
Assembly / Operating Instructions
Restraints - Harness
1.
To secure the child in the harness, place left
hand buckle prong (b) on top of (a).
2.
Hold both left hand buckle prongs (a) and (b)
together and insert it into buckle housing (e)
until it snaps into position.
3.
Repeat previous steps for right hand buckle
prongs (c) and (d).
4.
Once all attached, carefully adjust the harness
straps by pulling each slider (f) until the desired
fit is achieved in the lap, shoulder and crotch
straps.
5.
To release the buckles, squeeze the top and
bottom prongs (a) and (b), (c) and (d) together
until harness disengages.
CAUTION: Always adjust the harness when
changing the seating position of the child.
To adjust waist strap
1.
To loosen waist strap, push up both top and
bottom straps through buckle as circled in
diagram.
2.
To place waist strap in desired position, slide
the bottom strap into position then pull the top
strap and tighten into position.
f
f
a
c
f
f
b
d
e
f
(a), (b): Left hand buckle prongs
(c), (d): Right hand buckle prongs
(e): Buckle housing
(f): Strap adjustment sliders
Top strap
Bottom
strap
11

Advertisement

loading