Default Factory Setting - Maxspect Jump Series Owner's Manual

AP Mode Connection
EN
Though there is nothing to do with the internet while controlling the fixture through
AP Mode, according to the mechanism of the cloud-based controlling system, you
will still need to select a server before you can operate the APP. Principle of server
selection: select the same server on which you registered the account.
1. Press button B to check if the indicator is strobing in green, if not press and hold
button B for 6s to change to the AP Mode.
2. Open the WiFi list of the mobile device and choose the connection with the name
starts with "MJ-L1B0", input the password"123456789"(Unchangeable).
3. Open the APP, while a fixture with ID number starts with"MJ-L1B0"is shown on the
list of "Discovery of New Devices", it means that the fixture is connected to your
mobile device successfully*.
*The APP must be logged out before you can control the fixture. A fixture can be
connected to multiple mobile devices in AP Mode.
Turn On/Off the Fixture
Press and hold button A for 6s can turn on/off the fixture. While the fixture is
connected to mobile device in either Router Mode or AP Mode, you can turn it on by
doing any operation on the APP. After the fixture is turned on again or recovered
from power cut, it will be back to the previous working status before it was turned off.

Default Factory Setting

Indicator: Constant on in blue
Working Mode: Manual Working Mode Brightness: 100% for all channels
Reset Connection: Press and hold buttons A&B for about 3s, release the buttons
while the indicator is strobing in
Mode and the fixture will be un-bonded with the account.
Reset User Setting: Press and hold buttons A&B for about 6s, release the buttons while
the indicator is strobing in
Modes will be deleted and reset to the default factory setting.
8
Operating Instructions
Connection: Router Mode
red twice, the connection will be reset to Router
green twice, the user setting for Auto and Manual Working