Presser Foot Height And Direction - Singer 7285Q Service Manual

Original issue
Service Manual
May, 2014
13/38
Page
Model
7285Q

5. Presser foot height and direction

Checking
5.6 mm
1. Lower the feed dog below the needle plate.
2. Raise the presser foot lever.
3. Check and see if clearance between the needle plate and the presser foot is about
5.6 mm.
Adjustment
1. Remove the face cover, and raise the presser foot lever.
2. Loosen the screw (A) and adjust the presser foot height moving the presser bar.
3. Tighten the screw securely after checking the presser foot is parallel with the holes for
feed dog on the needle plate.
A
A