Advertisement
1 Phase Simplex
Control Panel for Grinder
and Vortex Pumps
Owner and Operational Manual
Installing the Starter Pack
#1. The Starter Pack (Fig. A)
comes pre assembled with the
start capacitor (1) run capacitor
(2) and start relay (3) mounted on
a plug and play bracket.
#2. Use the empty space on the top right side of the control panel to mount the Starter Pack. (Fig. 1).
To secure the Starter Pack to the control panel, place (Fig. 3) on top of (Fig. 2) by setting the bracket
on top of the screws (Fig. 4), then slide the bracket down so the screws are in the narrow part of the
mounting holes (Fig. 5), then tighten the screws.
(Fig. 1)
#3. After securing the Starter Pack inside of the control panel (Fig. 6) you will connect the wires from the Starter
Pack to the top of the terminal blocks (Fig. 7). W=White, B=Black, R=Red
(Fig. 6)
293 S. Wright St, Delavan, WI 53115 Phone: 1-866-973-6835 Fax: 800-426-9446
(Fig. A)
Top View
(Fig. 2)
(Fig. 3)
(1)
(2)
(Fig. A)
Side View
(Fig. 4)
(Fig. 7)
(3)
(Fig. 5)
Page 2 of 10
P10063VSM
Advertisement
