Bauknecht GSXP 70 POWER Installation And Maintenance Instructions Manual

GB GSXP 70 POWER
ON button
OFF button
Programme selection button
Press button P (repeatedly) until the required programme
number appears on the display.
Fault indication and wash time display
In normal operation it indicates the remaining time (h:mm),
whereas with "Delayed start" selected it indicates the time
remaining until programme start (hh).
In the presence of a fault indication "F .." –, consult the section
"5. What to do if...".
Rinse aid level indicator and salt level indicator
These indicator lamps light up when rinse aid or salt need to
be added.
Add just before starting a wash cycle.
Set the detergent
Press button P (repeatedly) to set the type of detergent used.
Powder, gel, tablets (standard): indicator off
Detergent with rinse aid:
Detergent with salt + rinse aid: right indicator
This deactivates the rinse aid and/or salt indicator.
"Half Load"/"Multizone"
Load the upper or lower rack only.
Press once = wash upper rack (the indicator/symbol lights up)
Press twice = wash lower rack (the indicator/symbol lights up)
Press 3 times = Off ("Half load"/"Multizone" deactivated).
When washing without the top rack, press the "Half load" (i.e.
"wash bottom rack") button twice; the indicator /corresponding
symbol lights up.
P
Programmes
1
Sensor +
2
Pre-Rinse
3
Hand washing
4
Quickwash
5 2)
Eco
6
Hygienic +
7
Overnight
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads,
extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness and power supply voltage.
2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories: for more detailed information on the
EN comparison test and other tests, contact the following address: "nk_customer@whirlpool.com".
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on Standard NF EN 13697 - November 2001.
Before using the dishwasher, read the
installation and maintenance instructions carefully!
left indicator
Table 1.1.
Programme chart
Available
options
40-70°C
cold
40°C
40°C
50°C
3)
55°C
Power Clean
High pressure with an additional jet for better washing results
and greater bottom rack load flexibility.
"Delayed Start" button
Press the button (repeatedly) to delay the start of the
programme. Adjustable from 1 to 24 hours. With each press
of the button, the delayed start indicator increases by one
hour and after 24 restarts from 00. Then press the START
button. The dishwasher will start after the set time.
START button
The indicator lights up during operation, flashes when a fault
occurs, and goes off at the end of the programme.
RESET button - for programme change or indication of faults
Press this button to cancel a started programme and selected
extra functions. Press this button to cancel the main fault
indicators (F..); also refer to the section "5. What to do if...".
The programme can then be selected and started.
Running programme indicator
A LED light projected on the floor indicates that the
dishwasher is working.
Detergent
Loading instructions large small Litres kWh
Normally or heavily soiled
crockery, including pots and pans.
Crockery to be washed later.
Light soiling, e.g. glasses and cups,
with a lower pressure jet.
Lightly soiled crockery, with no
dried-on food.
Normally soiled crockery. Energy
Saving Programme.
Normally or heavily soiled crockery,
with additional antibacterial wash.
Programme interruption (e.g. due to
door opening) can compromise
elimination of germs.
Normally soiled crockery, gentle
and quiet (39 dbA) thanks to the
lower pressure jet.
Consumption
dispenser
Minutes
X X 7-17 0.99-1.58 65-170 ±
— — 4.0 0.03
X — 10.0 0.85
X — 10.0 0.65
X X 11.0 1.05
X X 13.0 1.50
X X 13.0 1.20
5019 496 01108
1)
1)
1)
14 ±
1)
125 ±
1)
30 ±
1)
170 ±
1)
115 ±
1)
290 ±
1