Bosch GBH18V-36C Operating/Safety Instructions Manual page 15

160992A536_GBH18V-36C 1/20/20 2:02 PM Page 15
Slow increase in speed for controlled
chiseling. Soft start is enabled for
precise control and positioning.
In Favorite work preset, the power tool
can be customized via 'Bosch Toolbox'
app.
- For "Drilling" operating mode: Ramp-
up speed and maximum RPM can be
customized. Kickback Control can be
toggled on/off or sensitivity can be
configured.
- For "Hammering" mode: Soft start
can be enabled/disabled.
Refer to "Using 'Bosch Toolbox' app"
chapter for more information.
Adaptive Speed Control
In "Hammering" operating
mode, the power tool starts
at a low idle speed for better
control
positioning. When force is
applied to the workpiece, the speed
quickly increases.
Slip Clutch
The tool has a internal pre-set slip
clutch. The output spindle will stop
rotating if the accessory binds and
overloads the tool.
Vibration damping
the generated vibration.
Do not use the power tool if the
vibration damper 5 is damaged (Fig. 1).
Kickback Control
The rapid shut-off feature
enables better control and
improves user's comfort. The
power tool automatically shuts
off in case of sudden and
unexpected rotation of the power tool
around the drilling axis (for example
jamming of the drill bit in reinforcing steel
or wedging application tool). To restart
the power tool, release the trigger switch
Operating Instructions
Tool Tips
and precise
The integrated
vibration damping
function reduces
-15-
and then actuate again.
Kickack Control can activate only when
the power tool is running at maximum
operating speed and can rotate freely
around the drill bit axis.
For the best penetration rates in
concrete, run the tool with a steady
pressure, but do not use excessive force
as this will decrease the efficiency of
the tool.
All hammers require a short period of
time to warm up. Depending on the
room temperature, this time may vary
from approximately 15 seconds (90°F /
32°C) to 2 minutes (32°F / 0°C). A new
hammer requires a break-in period
before full performance is realized. This
period may require up to 5 hours of
operation.
A combination hammer is likely to be
the most expensive portable tool at the
construction job. The long wear and
efficient operation of the BOSCH
hammers will more than justify the cost
for tools of this type. As earlier pointed
out, sharp accessories as well as clean
air vents are necessary for efficient
operation. Establish and follow a set
maintenance program.