Table of Contents
Advertisement
Quick Links
ASSEMBLY, INSTALLATION, AND OPERATION INSTRUCTIONS
NOTICE: All Manual information is subject to change without notice. Revised editions
will be available for free download at LetsGoAero.com. Manual information is considered
factual until made obsolete by a revised version.
Follow this QR-Code or visit
LetsGoAero.com/manuals to check for an updated version:
Copyright© 2019, Lets Go Aero, Inc., All rights reserved.
VT4-B00284-121219Rev
PRODUCT MANUAL
Page 1 of 4
Four Bike Vertical V-Rack™ Floor Stand
QTY. DESCRIPTION
A
1
BASE
B
2
LEG
C
12
6MM BOLT
D
8
6MM NUT
E
2
PLASTIC SEPARATOR
F
1
RISER
G
1
UPPER SUPPORT
H
4
WING SUPPORT ARMS
I
8
WHEEL CRADLE
J
8
RETAINER CLIP
To register your product,
visit the LetsGoAero.com/registration
For More Information & Accessories,
Visit our Website - www.LetsGoAero.com
For Technical Support & Product Questions Contact Us:
877-464-2376 or 719- 630-3800
Email: Support@LetsGoAero.com
Let's Go Aero, Inc. 4474 Barnes Road
Colorado Springs, CO 80917, USA
Patent and trademark protected:
Patent Number 8,889,456; Patents Pending
V-Tree™ 4
Part No. B00284
PARTS
Revision Date: 12/12/19
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Let's Go Aero V-Tree 4
Summary of Contents for Let's Go Aero V-Tree 4
- Page 1 V-Tree™ 4 Four Bike Vertical V-Rack™ Floor Stand Part No. B00284 PRODUCT MANUAL ASSEMBLY, INSTALLATION, AND OPERATION INSTRUCTIONS PARTS QTY. DESCRIPTION BASE 6MM BOLT 6MM NUT PLASTIC SEPARATOR RISER UPPER SUPPORT WING SUPPORT ARMS WHEEL CRADLE RETAINER CLIP To register your product, visit the LetsGoAero.com/registration For More Information &...
- Page 2 STEP 1: Connect both Legs [B] to the Base [A] using two (2) 6mm Bolts [C] and one (1) Plastic Separator [E] to secure each Leg as shown. [Fg. 1] [Fg. 1] STEP 2: Align the holes on the Riser [F] to the holes located on the vertical bracket of the [Fg.
- Page 3 STEP 4: Slide the Foam Pads on the Wings [H] [Fg. 6] [Fg. 7] down to reveal the holes near the edge of the Wing. FOAM BUMPERS Align the holes on the edge of the Wing [H] with holes located on the Base [A] and the Upper Support [G].
- Page 4 IMPORTANT: For two bicycles, position the bicycles facing in opposite directions (front-to-back/back-to-front) with the chain ring to the outside. IMPORTANT: Always LOAD bicycles starting with the LOWER SECTION of the V-Tree 4 first. IMPORTANT: When UNLOADING start from the UPPER SECTION first.
Need help?
Do you have a question about the V-Tree 4 and is the answer not in the manual?
Questions and answers