Cleaning & Maintenance - Kruger Vigo KCG30 User & Installation Manual

CLEANING & MAINTENANCE
Before cleaning or servicing your cooktop, disconnect it from the
!
electrical mains and allow it to cool down.
General Cleaning
Wash enameled parts with lukewarm water and detergent. Do not use
abrasive products which might damage them.
Wash the flame caps and burner caps often with boiling water and detergent,
taking care to remove all deposits. The hob pan stands can also be washed in
a dishwasher.
For stubborn grime, use ordinary non-abrasive detergents or specific
commercial products. We strongly advise you not to use scouring pads, steel
wool or acids for cleaning.
Cleaning Ignition Plugs
Automatic burner ignition is provided by a ceramic "ignition plug" and a metal
electrode (B in fig.1 page 7). Clean these parts thoroughly periodically. To avoid
ignition difficulties, check that the cavities in the burner are not obstructed.
To remove deposits from the burner cavities, remove the cap and separate the
two parts (fig. 1 page 7). After cleaning, put the parts back together and return
them correctly to their position. After washing, replace the hob pan stands,
checking that they are correctly positioned before placing a cookware on top.
Routine Maintenance
Have the condition and efficiency of the gas pipe and the pressure regulator
checked periodically. If anomalies are found, do not attempt to repair, but have
the faulty part replaced completely.
To ensure good performance and safety, the gas regulator taps must be
greased periodically.
Periodic lubrication of the taps must only be carried out by qualified
!
personnel, who must also be contacted if the appliance malfunctions.
9