Kruger Vigo KCG30 User & Installation Manual page 14

Setting Minimum Flame Level
1. Light the burner
2. Turn the knob to the minimum position
3. Remove the control knobs.
4. Use a thin straight screwdriver to turn the by-pass pin located next to the
tap rod. For LPG, turn the by-pass pin fully clockwise.
5. The result should be a small, homogeneous flame which is uniform around
the entire burner ring.
6. Finally, check that the burner does not go out when the tap is turned
quickly from the maximum to the minimum position.
Electrical
The appliance is profited to operate with a power supply voltage of 120V
single-phase. The connection must be made in accordance with the
regulations and laws in force.
Before making any electrical connections, make sure that:
❏ The safety circuit-breaker and the electrical system are able to withstand
the load of the appliance (see nameplate).
❏ The power supply system has a grounding connection in good working
order in accordance with the regulations in force;
❏ The socket or omni polar switch used are easily accessible with the
appliance installed.
A plug has been outfitted on this appliance so you can easily connect it to a
suitable safety socket. If you wish to make a direct connection to the mains,
an omni polar switch with a gap between the contacts of at least 3mm, of
suitable rating for the load and complying with the regulations in force, must
be installed between the appliance and the mains. The switch must not break
contact in the yellow/green grounding wire.
Color
Yellow/Green
Blue
Brown
14
Property
Ground
Neutral
Live