WESTECH LDC-01 Quick Start Manual

Thank you for selecting the product. LDC-01(LED Driver Controller) is an optional accessory for DCCP series LED DC
driver. It can realize max. 4 -timer working. For each timer, 0~9 working hours and 0~100% output power is adjustable.
The output power can also be adjusted automatically with changes of battery voltage and temperature. Read this manual
carefully and thoroughly so as to preferably install and use the product. Under normal service conditions, the warranty
period of the product is two (2) years free of charge, starting from the sales date.
 Introductions:
Output
terminals
Input
terminals
As shown in above picture:
Input terminals: connect controller or other DC power supply.
Output terminals: connect DCCP series LED driver. PWM frequency is 200Hz.
Button: Set the working hours and power percentage.
Display bar: Display the timer and power percentage.
Temperature sensor: fit to the heat sink of LED source.
 Functions:
Operations:
1. Under non-setting state, press the button lightly, LED indicators are lighted circularly each time,
2. Press the button for more than 5 seconds till the LED indicator flashing. Release it at this moment. Then press the
button to choose the desired number.
3. Under the setting state, if the desired number appears, stop pressing the button. When the LED indicator stops
flashing, the setting is successfully.
4. If there is no any button pressing within 15 seconds, the LED indicator and digital tube will be turned off
automatically for power saving.
LED Driver Controller LDC-01
— For DCCP series LED driver
~ 1 ~
Temperature sensor
Display bar
Button
Solar Charge Controller
-
Load