AGFA DuoScan Owner's Manual page 33

1. Set the scanner to an unused SCSI ID number between 1 and 6.
For more information, see
2. Connect the larger 50-pin end of the SCSI cable to the connector at the rear of your PC.
Use the SCSI cable supplied with the scanner.
3. Place the terminator at the 50-pin connector of the scanner. Snap the diamond shaped wire
clips into the clip brackets to secure the connection.
4. Connect the smaller 25-pin end of the SCSI cable to the free connector of the scanner.
If your PC has a 50-pin connector and your DuoScan will be connected to your PC together
with other SCSI devices:
n
If you install the scanner at the end of your SCSI chain:
1. Set the scanner to an unused SCSI ID number between 1 and 6.
For more information, see '
2. Connect the 50-pin end of the SCSI cable to the connector at the rear of your device.
Use the cable supplied with the scanner.
3. Place the terminator on the 50-pin connector of the scanner. Snap the diamond shaped wire
clips into the clip brackets to secure the connection.
4. Connect the 25-pin end of the SCSI cable to the scanner.
'Choosing a SCSI ID number'
Choosing a SCSI ID number'
earlier in this chapter.
earlier in this chapter.
Chapter 2 — Installing the scanner 33