C. Connect the base unit
1) Connect the AC adapter to the DC IN 9V jack and to a
standard 120V AC wall outlet.
2) Set the base on a desk or tabletop, and place the
handset on the base unit as shown. (For wall mounting,
see "Mounting the Base Unit on a Wall", on page 12.)
3) Raise the antenna to a vertical position.
4) Make sure the charge/in use LED illuminates. If the
LED does not illuminate, check to see that the AC
adapter is plugged in and the handset makes good
contact with the base charging contacts.
• Connect the AC adapter to a continuous
power supply.
• Place the base unit close to the AC outlet so that
you can unplug the AC adapter easily.
• After installing the battery pack in the handset, charge your handset at least
15-20 hours before plugging into the phone line.
5) Once the handset battery pack is fully charged, connect
the telephone line cord to the TEL LINE jack and a
telephone outlet.
If your telephone outlet isn't modular, contact
your telephone company for assistance.
www.uniden.com
Modular
G E T T I N G S T A R T E D
• Use only the supplied
AD-314 AC adapter.
Do not use any other
AC adapter.
• Place the power cord so
that it does not create a
trip hazard or where it
could become chafed
and create a fire or
electrical hazard.
The handset can be placed
face up or face down on
the base for charging.
[ 11 ]