Table of Contents
Advertisement
OBJ_BUCH-1900-001.book Page 19 Monday, May 13, 2013 11:40 AM
The rear edge of the measuring tool is preset as the reference plane for the
measurement.
For a wall to wall measurement, as an example, position the measuring
tool with its rear edge against the initial wall.
Do not point the laser beam at persons or animals and do not look
into the laser beam yourself, not even from a large distance.
"HOLD" Function (see Figure B)
Press the "HOLD" button 2 to stop the measur-
ing procedure. The laser beam is switched off
and the HOLD indication appears on the dis-
play. The current measuring value is still dis-
played in the bottom line of the display, but is
no longer continuously updated.
Press the "HOLD" button 2 once more to
switch the laser on again. The LASER indicator
flashes on the display. The previous measuring
value is displayed in the top line. The continu-
ously updated/current measuring value is dis-
played in the bottom line.
Press the "HOLD" button 2 once more to stop
the measuring procedure again. The laser
beam is switched off and the HOLD indication
appears on the display. The previous measur-
ing value is displayed in the top line. The cur-
rent measuring value is displayed in the bot-
tom line, but is no longer continuously
updated.
When no button on the measuring tool is pressed for approx. 5 minutes,
the measuring tool automatically switches off to save the batteries.
When a measuring value was held using the "HOLD" function, it is retained
after the automatic shut-off. After switching the measuring tool on again
by pressing the "HOLD" button 2, the previous measuring value e is indi-
cated in the top line of the display.
Bosch Power Tools
English | 19
2 609 140 991 | (13.5.13)
Hide quick links:
Advertisement
Table of Contents
