Advertisement
•
If you are installing a premium seat on a traction
unit with a standard seat installed, complete the
following procedure:
1.
Park the machine on level ground, shut off
the engine, engage the parking brake, and
remove the ignition key.
2.
Remove the 2 carriage bolts and nuts
securing the armrest to the seat
Save the fasteners.
Important:
armrest after removing it so that it does
not crimp or hang by the cables and
wires.
1. Armrest
2. Armrest bracket on the
seat
3.
Remove and discard the 4 nuts securing the
seat rails to the seat pan and remove the
seat
(Figure
3).
(Figure
Ensure that you support the
Figure 2
3. Carriage bolt
2).
1. Seat rail
2. Seat pan
g015248
2
Figure 3
3. Flange nut (discard)
g015247
Advertisement
