2.
Install the armrest to the seat using the 2
carriage bolts and flange nuts that you removed
previously
(Figure
Note:
If you have a diesel machine, install the
spacer removed in
(page
1).
Figure 5
1. Armrest
2. Armrest bracket
3.
Connect the open connector in the main wire
harness (located to the right rear of the seat) to
the short wire harness that came with the seat
(Figure
6).
5).
1 Preparing the Machine
3. Carriage bolt
(Premium seat harness shown)
1. Open connector on the main wire harness
2. Short wire harness from the kit
4.
Connect the connector on the short wire harness
to the open port on the back of the seat (premium
seat) or under the seat (standard seat).
5.
Use cable ties to secure the wire harness to the
choke/throttle cable.
g195603
g195604
4
Figure 6
g015301