Advertisement
INSTALLING AC MANAGER 5
10
Fixing AC Manager 5 to the wall
AC Manager 5 can be installed by fixing to the
wall.
To install AC Manager 5 in adequate place,
proceed according to the following instruc-
tions.
Here, it describes the installation method of
AC Manager 5 with the example of installing
AC Manager 5 on the wall.
• Decide the space to install AC Manager 5
Before installing AC Manager 5, check if it is
an adequate place for the connection of AC
Manager 5, power, and LAN cable.
• Use driver to fix on the wall. According to
the installation location, you can fix it as in
the following figure.
PACM5A000
Connecting Ethernet cable (LAN
cable) to AC Manager 5
AC Manager 5 can be connected to hub or
directly to the internet network through
Ethernet cable.
It is the case of connecting AC Manager 5 to
the basic internet network installed at the site,
and it is generally connected a hub.
In such case, Ethernet cable shall be connect-
ed as a direct cable.
Use Ethernet cable to connect to LAN port of
AC Manager 5.
Setting AC Manager 5 net-
work address
After connecting AC Manager 5 to various
devices via the cable, the network environ-
ment of AC Manager 5 should be set by start-
ing AC Manager 5. The following information
should be set to use AC Manager 5.
• IP address of AC Manager 5
• Gateway address
• Netmask
CAUTION
!
Setting the network environment informa-
tion
Without the above information input, com-
munication defect may occur or control
through AC Manager 5 may be impossi-
ble. Therefore, take caution and input cor-
rectly.
Before setting AC Manager 5 envi-
ronment
The network environment of AC Manager 5
can be set by the LCD and the buttons at the
front side of AC Manager 5.
The current AC Manager 5 information and
the menu are displayed on the LCD, and the
menu can be changed and selected by press-
ing
and
button and
Up/Down/Left/Right (▲, ▼, ◀, ▶) buttons.
PACM5A000
PACM5A000
Advertisement
