Trouble Shooting - Zanussi ZDV300 User Manual

■ Trouble Shooting

Trouble
The programme
does not start
Cabinet
becomes hot or
emit odor
Clothes too dry
Clothes shrink
Hairball on
clothes
The sound of dryer may caused by

Due to heavy wet clothes turning and bumping, and this will cause noise accordingly.

Air bumping: When drying, machine will generate steam which will come out from pipe and this will
cause bumping with the bottom of inner tube.
Error code
E33
Cause
 Power cut.
 The power plug is not fully
plugged.
 The clothes in machine are over
loaded.
 The temperature fuse is cut.
 The lint filter is dirty.
 The uptake or exhaust duct is dirty.
 The clothes in machine are over
loaded.
 Not to take out the clothes in time
when finish.
 The clothes don't assort properly.
 The temperature is too high.
 Clothes excessive drying after
laundry.
 It is right for synthetic fiber and
permanent press fiber causing
hairballs. This is because the right
rub causing.
Description
Temperature
Sensor error
Solution
 Wait for switching on electricity.
 Check the power socket, make sure fully
plugged.
 The clothes in dryer must be after
spinning, and drying clothes cannot
exceed 3kg.
 Please arrange technician restore the
temperature fuse.
 Make sure clean the lint filter in time.
 Clean out the stem.
 Make sure the clothes are not too full.
 Take out the clothes immediately when
finish.
 Observe the Laundry Labels.
 Observe the Laundry Labels.
 If easy to shrink, please check in
advance.
 Take out the clothes when they are not
fully dry.
 Then hang the clothes until full dry.
 Use fabric softener lubricate fiber,
please spray settled gule on cuff and
neckline when iron clothes. Turn the
sarcenet out for reducing rub.
Criteria
Temperature Sensor
is open or short
13
Action after fault denounced
Stop the program and contact
service team