Klutch 62249 Owner's Manual page 10

Possible
Failure
Cause
The swivel
The swivel seal
seal does not
is broken.
work.
Install a new swivel:
1. Turn off the pressure source, release pressure from the system,
and remove the supply hose connection from the swivel.
2. Remove the swivel assembly (6) from reel axle.
3. Remove the circlip from the swivel and take it apart. See the
diagram below for reference.
4. Replace the seals and reassemble the swivel.
5. Use Teflon tape or thread sealant on the swivel threads and
reconnect the swivel with the axle.
6. Use Teflon tape or thread sealant on the inlet supply hose
threads and reconnect it to the swivel.
7. Pressurize the system and check for leaks.
Swivel Assembly Parts List:
6-1: Washer (1)
6-2: O ring or Seal (1)
6-3: Washer (1)
6-4: Swivel Shaft (1)
6-5: Bearing Cover (1)
6-6: Ball Bearing (1)
6-7: Bearing Washer (1)
6-8: Washer (1)
6-9: Lock Washer (1)
Page 10 of 14
Corrective Action