KTM 350 EXC-F 2017 Setup Instructions page 6

2 SETUP
–
Position turn signal indicator lamp {2} in the speedometer bracket.
H01768-10
–
Mount the connector retainer and speedometer on the upper triple clamp.
–
Mount and tighten screws
Guideline
Remaining screws, chassis
–
Route the clutch line with the clutch master cylinder toward the front between
the upper and lower triple clamps.
–
Install the fork legs. (
S01408-10
(EXC‑F EU/AU/BR, EXC-F US)
–
Remove screws
–
Move the handlebar supports to the desired position and mount and tighten
screws
Guideline
Screw, handlebar holder
S01414-10
–
Position the handlebar.
–
Position the handlebar clamps. Mount and tighten the screws evenly.
Guideline
Screw, handlebar clamp
E00483-01

.
p. 19)
 and take off handlebar supports.

.
M10
Info
Position the left and right handlebar supports evenly.
Info
Make sure the cables and wiring are positioned correctly.
Info
The markings on the handlebar should be at the center of the handlebar
clamps.
Keep the gap widths equal when tightening.
M6 10 Nm
(7.4 lbf ft)
Loctite
40 Nm ®
(29.5 lbf ft)
M8 20 Nm
(14.8 lbf ft)
4
243™