Unitec DK01-A Operating Manual

Automatic Drill DK01-A

Major Technical Parameters:

1. Drilling Material:
2. Drilling Capacity:
3. Hole Diameter:
4. Table Stretch:
5. Table Standard Hole Distance:
6. Max Table Working Width:
7. Specified Wattage:
8. Power:
9. Net Weight:
10.Fuse Capacity:

Installation:

1. Unpack the machine by holding the channel steel rods at the machine bottom and
pulling it out of the foam. Caution: Never pull the plastic case.
2. Assemble the front table by setting the two guide wheels onto the two sides of the
conductive plate to make the table bottom touch the channel steel rods, gently
pushing forward the table and fixing it with the two pegs.
3. Connect the machine to power. Switch it on and it is ready for work when the
power indicator is on. Be sure to use a 220/50Hz socket with good ground
connection.

Operation:

1. Check papers to be drilled for any staples and clips before drilling to avoid any
damage to the machine.
2. Adjust the front table to a proper position by first loosening the pegs to move the
table and then fixing them when the table is at the right place.
3. Fix the drill bit after selecting a right one with right diameter. (The machine is
furnished only with the very bit for 6-hole drill, and other bits may be obtained
Operating Manual
papers
48mm for ⊙5mm—⊙8mm
38mm for ⊙4mm
28mm for ⊙3mm
⊙3-⊙8mm
vertically 22mm, horizontally 240mm
3 holes: ⊙ 80 ⊙ 80 ⊙
3 holes: ⊙ 108 ⊙ 108 ⊙
4 holes: ⊙ 80 ⊙ 80 ⊙ 80 ⊙
4 holes: ⊙ 45 ⊙ 65 ⊙ 45 ⊙
6 holes: ⊙ 19 ⊙ 19 ⊙ 50 ⊙ 19 ⊙19⊙
340mm
210w
220v/50Hz
34kg
2A (Ø5×20)
1