Panasonic KX-TGA405 Installation Manual page 3

TGA405(option)_(e-e).fm Page 3 Wednesday, March 5, 2014 4:56 PM
Installation/Registering the range extender to the base unit
Once the unit is connected to a power outlet in step 3, it automatically goes into
registration mode (if not already registered).
1
Range extender: Connect the AC adaptor.
L Use only the supplied Panasonic AC adaptor PQLV219.
2
Base unit: Press and hold {LOCATOR} for about 5 seconds.
L Depending on the base unit, a registration tone sounds.
L If all registered handsets start ringing, press the same button to stop. Then
repeat this step.
L The next step must be completed within 90 seconds.
3
Range extender: Connect the AC adaptor to a power outlet.
L When the unit is turned on, the STATUS indicator and w indicator light amber
for about 2 seconds.
4
Range extender: Confirm that the STATUS indicator and w indicator light
green. (The unit is ready for use.)
L If the indicators do not light green, re-position the unit in a place where the
indicators light green.
5
Base unit: To exit registration mode, press {LOCATOR}.
Note:
L The AC adaptor must remain connected at all times. (It is normal for the adaptor to
feel warm during use.)
L The AC adaptor should be connected to a vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a ceiling-mounted AC outlet, as the weight
of the adaptor may cause it to become disconnected.
L The unit can support a maximum of 2 handsets at a time.
L Up to 2 range extenders can be registered to the base unit.
3
For assistance, please visit http://www.panasonic.com/help
Hook
Press plug firmly.
(120 V AC, 60 Hz)