Download Print this page

Lassco Wizer Cornerounder CR-177 User Manual

Table of Contents

Download this manual

CR-177 Cornerounder

Before operating this equipment,

please read these instructions

completely and keep these operating

instructions for future reference.

ProSource Packaging, Inc.

14911 Stuebner Airline Suite A

Houston, TX 77069

800-203-0233

www.Machine-Solution.com

Serial Number:

Date of Purchase:

Dealer:

Address:

Telephone Number:

Table of Contents

Need help?

Do you have a question about the Cornerounder CR-177 and is the answer not in the manual?

Page 1 CR-177 Cornerounder ProSource Packaging, Inc. 14911 Stuebner Airline Suite A Houston, TX 77069 800-203-0233 www.Machine-Solution.com Before operating this equipment, Serial Number: please read these instructions Date of Purchase: completely and keep these operating Dealer: instructions for future reference. Address: Telephone Number:...
Page 2 Safety Instructions Keep fingers away from the cutting area and blades when operating. Use caution when releasing the handle, be advised it is spring loaded. Do not use this machine to cut metal. Loose Materials Inventory Remove and inspect the following items: Blade (2) Die (1) HEX-18:...
Page 3 Setting Up Your Machine Install the handle: Loosen the Lever Knob that is on top of the Blade Holder. Place the Lever Axle into the Channel on top of the Blade Holder making sure the lower end of the Lever is placed under the Bearings. Secure the Handle by tightening the Lever Knob.
Page 4 Cutting After the machine has been properly aligned you are ready to cut: Place the product you are cutting on the surface of the machine. Please note that this machine can only handle up to a maximum of 1” of product. This amount will vary depending on what you are cutting.