Accu-Sort AXIOM Quick Reference Manual

An AXIOM typically includes:
• AXIOM Scan Head
• Wiring Base
• Power Supply
Options that may be included:
• Universal Mounting Bracket
• Trigger Photoeye
Time Required: 45 minutes / unit
• Mechanical installation (30 minutes)
• Electrical installation (15 minutes)
• Setup
(see AXCESS Quick Reference Guide)
Tools Required:
• Phillips Long-Handled #2 Screwdriver
• Slotted screwdriver (1/8")
• Adjustable Wrench (open-ended)
• Tape Measure
Quick Start References:
• AXIOM/AXIOM-X Product Line Manual
• Mounting structure drawings
Other Useful References:
• AXCESS for AXIOM Quick Reference Guide
• Interconnect drawings located in
AXIOM/AXIOM-X Manual, App. E (p.209):
107480 - Controller/Client with Tach
107481 - Controller/Client/Client w/Tach
107482 - Start/End Trigger Photoeyes
107483 - Stack Light with Internal Relays
NOTICE: Application-specific documenta-
tion provided with your equipment may
supersede the information provided here.
AXIOM | Line Bar Code Readers
AXIOM Line Bar Code Reader
™
Quick Reference Guide
Introduction
The AXIOM is designed for easy installation and setup. Use this guide as a cross reference to
locate the content you need in the AXIOM/AXIOM-X Product Line Manual.
Safety Precautions
(Chapter 2)
Observe all safety precautions regarding:
• Power, electrical, grounding (p. 13)
• Electrostatic discharge (ESD) (p. 14)
• Laser Exposure (p. 15)
Mechanical Installation
1. Assemble mounting structure according to your mounting diagram, if applicable.
2. Mount wiring base in the defined location using orientation consideration
as a guideline (p. 19-21). A universal mounting bracket is available (p. 24-26).
3. Mount the Trigger Photoeye and reflector (p. 30).
4. Mount the tachometer, if applicable (p. 33).
5. Install optional I/O modules into wiring base, if applicable (p. 34-35).
Electrical Installation
Use the wiring base label (see side 2) as a reference when performing electrical
installation.
1. Properly ground wiring base to protective earth (PE) ground (p. 46-47).
2. Connect power supply to wiring base
and perform polarity check (p. 51-53).
3. Connect Trigger photoeye to Trigger
terminal blocks (p. 54).
4. Connect tachometer to TACH terminal
blocks and use ferrite clamps (p. 55-56).
5. Connect RS232/422 communications
to SERIAL COM terminals (p. 57).
6. Connect Ethernet communications
to ETHERNET terminals (p. 58).
7. Connect I/O module wiring to I/O 1 through I/O 4, as required (p. 59-60).
8. Install scan head to wiring base as outlined in Chapter 3 (p. 39-42).
Setup and Operations
1. Use the first-time startup / setup procedures and operations checklist (p. 118-119).
2. Use AXCESS and a setup cable (p. 71) or network connection (p. 73) to modify
operating parameters (p. 75-104).
onitor operations using AXIOM Monitor and Log Viewer diagnostics (p. 124).
3. M
4. Backup parameters to the wiring base using AXCESS or the connector panel (p.104).
| Laser
Observe Laser Safety Warnings on AXIOM
(Chapter 3, see also mounting illustrations, side 2)
(Chapter 4, Appendix E)
Installing Scan Head to Wiring Base
(Chapter 5 and 6)