Advertisement
Screw locks type slide rail installation
▼If you want to use the screw lock type slide rail to mount the server into the rack, do the
following.
1. Remove the 2 screws at the bottom of the chassis with a Philips screwdriver as shown
below.
2. Perform the following actions to remove the two plastic stands.
As shown in the figure, loosen the 2 screws of the fixed plastic stand with a Philips
screwdriver, and then press the snap-fit with your fingers to disengage the plastic stands
from the chassis.
Server Rack Installation Instructions 2019/04/24
2
Advertisement
