Installing Batteries - ALTAI T330BZ Instructions Manual

INSTALLING BATTERIES

The T330BZ requires one PP3-size 9 Volt battery.
1. If the detector is on, turn it OFF.
2. Press on the battery compartment cover and slide the cover off in the direction
of the arrow.
3. Insert the battery into the compartment as indicated by the polarity symbols (+
and –) marked inside the compartment.
4. Replace the cover.
•
Always remove old or discharged batteries; batteries can leak chemicals that
can destroy electronic parts.
•
If you do not plan to use the detector for a week or more, remove the
batteries.
•
Dispose of old batteries promptly and properly.
SETTING UP
ADJUSTING THE SHAFT
1. Loosen the locknut (5)
2. Lengthen or shorten the stem (6) so
that when you stand upright with the
detector in your hand, the search coil is
level and about 12 mm to 50 mm (½" to
2") above the ground with your arm
relaxed at your side.
3. Tighten the locknut
ADJUSTING THE SEARCH COIL
Loosen the knobs (7) that attach the
search coil to the shaft, then adjust the
search coil to the desired angle. (The
search coil should be parallel with the
ground). Tighten the knobs just enough
to keep the search coil from rotating or
wobbling.
Page 4