Disassembling The Mobility Device For Transport; Disconnecting The Remote - Invacare Pronto M41 Series User Manual

Invacare® Pronto™ M41 Series with SureStep®
The safety belt installed in the transporting vehicle should
be applied as shown in the illustration above.
1) Center line of the body
2) Center of the sternum
9.4 Disassembling the mobility device for
transport
CAUTION!
Injury hazard
– If you are unable to fasten your mobility
device securely in a transport vehicle, Invacare
recommends that you do not transport it!
100
• Before transporting your mobility device, make sure the
motors are engaged and that the remote is switched off.
Invacare strongly recommends that you additionally
disconnect or remove the batteries. Refer to 9.4.4
Removing/Installing the batteries, page102 .
• Invacare strongly recommends securing the mobility
device to the floor of the transporting vehicle.
Proceed as follows to disassemble the mobility device for
transport:
1. Disconnect the remote. Refer to 9.4.1 Disconnecting
the remote, page 100 .
2. Remove the seat. Refer to 9.4.2 Removing/Installing
the seat, page 101 .
3. Remove the top shroud. Refer to 9.4.3
Removing/Installing Top Shroud, page101 .
4. Remove the batteries. Refer to 9.4.4 Removing/Installing
the batteries, page 102 .

9.4.1 Disconnecting the remote

1. Switch off the remote.
2.
Pull the plug A of the remote cable to disconnect the
remote.
1553378-G