Disassembly; On The A-Frame - ICARO 2000 Piuma Series Owner's Manual

Icaro 2000
06/06/2019

7. Disassembly

As with assembling your glider, disassembly must be performed with the glider on the frame.

7.1 On the A-Frame

7.1.1 Starting Point
Stand the glider with its tail into wind.
•
Slightly loosen the crossbar removing the nose plate and fixing it to the tension handle.
•
Extract the rear-most section of keel by depressing the spring button and pulling the rear of the
•
section; this section remains attached with a bungee.
Swing down the free section of the keel, allowing the main part to rest on top of it. This way you can
•
remove the battens easily.
Note: it is suggested to assemble as described in the procedure, seen that it is possible to forget to
hook in the cross bar before taking off.
Remove the battens starting from the extreme part of the wing towards the central part of the
•
wing.
Unzip the wing-tip zipper, grasp the tip-lever by the cord and pull it towards the outside.
•
Holding the lever with one hand, and the tip-wand with the other, pull back the tip-lever,
•
releasing the tip-wand from the cup.
Rotate again the tip-lever in the inside of the sail and close the zipper. Place the tip-wand with
•
the battens.
Piuma - Owner Manual
Page # 11 / 44
Piuma 2019-1-En