GMI SRI Series Manual

TOOLS REQUIRED FOR ASSEMBLY

Cordless drill with Phillips head Bit & magnetic extension,
3/8" Magnetic socket bit.

BEFORE ASSEMBLING WORKBENCH

Read through the assembly instructions to
Familiarize yourself with the order in which the
parts are assembled. We suggest that you clear
& vacuum the area where the bench is to be
assembled. It is important that the bench is
assembled in the same sequence as instructed.
HARDWARE & GMI COMPONENTS
All assembly hardware is provided.

ASSEMBLE BASE COMPONENTS

Attach modesty panel to legs as shown using
the provided 1/4-20 X 1/2" flange head bolts
Next attach the front brace as shown using
the provided same bolts.
CPU RACK & WIRE BLIND
Use 10-32 X 1/2" pan head Phillips to attach
the rear wire blind to the cpu rack as shown
bolting through the CPU rack into the threaded
fasteners installed in the wire blind.
Next, bolt the rack assembly to the leg as
shown using the provided 1/4-20 X 1/2" flange
head bolts.
10-32 X 1/2" 1/4-20 X 1/2"
PAN HEAD PHILLIPS FLANGE HEAD BOLT

CONNECT TOP TO BASE COMPONENTS

Place the work surface upside down on clean
floor. Position the base over the top as shown so
that the leg holes will align with the pre-installed
Threaded fasteners in the under side of the work
Surface. Attach legs with provided 1/4-20 x 1/2" flange
Head bolts. Use the #14 x 3/4" Lag screws to secure
Through the brace and into the work surface.

WIRE TRAY / MODESTY

Use the #10 x 5/8" SPAX to attach
the wire tray through the provided
holes in the modesty panel and into the work surface
to secure as shown. Depending the length of the
work station additional holes may be present.
#10 x 5/8" SPAX
COARSE THREAD 1/4-20 X 1/2"
FLANGE HEAD BOLT
PAN HEAD PHILLIPS
LEFT LEG
#14 x 3/4"
LAG SCREW
SRI FLIP TOP WORKSTATION
MODESTY PANEL
FRONT BRACE
REAR WIRE
BLIND
CPU RACK
RIGHT LEG
THREADED
INSERTS