Table of Contents
Advertisement
INSTALLATION
1) CRUISE MODULE MOUNTING
NOTE: DO NOT MOUNT THE CRUISE MODULE IN THE FOLLOWING AREAS:
* Under the fender, Under the vehicle, Directly to the engine, With the cable pointed down, Near sharp, hot or moving
objects, Near ignition coil [No closer than 255mm (10")], In the passenger compartment (could hear internal motor
operating), Or where it will interfere with service checks.
A. Select a possible location to mount your CRUISE MODULE, set the CRUISE MODULE unmounted in that area.
The reason for leaving the CRUISE MODULE unmounted is to make sure the CRUISE HARNESS will reach the
passenger compartment and the CRUISE CABLE will reach
the throttle attaching point.
B.Once you have selected a location, install the MODULE
BRACKET to the the CRUISE MODULE with the two (2)
MODULE BOLTS provided. It may be necessary to cut and
bend the MODULE BRACKET to achieve a custom fit.
NOTE:
DO NOT OVERTIGHTEN! DAMAGE TO THE CRUISE
MODULE WILL OCCUR IF THE BOLTS ARE
OVERTIGHTENED.
C. Mount the CRUISE MODULE in the spot you have selected
using two (2) of the SELF-THREADING BOLTS provided in
the kit. Be sure to set the programming switches located
underneath the rubber grommet of the CRUISE MODULE
before mounting the Cruise Control.
WARNING
Failure to follow the instruction manual could not only cause the Cruise Control to work improperly, but could cause the
throttle to hang up, possibly causing damage to your vehicle and injury and/or death to you and your passengers.
2) MEASURING THROTTLE CABLE TRAVEL
THIS IS A VERY IMPORTANT STEP. FAILURE TO DETERMINE THROTTLE
CABLE TRAVEL COULD CAUSE DAMAGE TO YOUR VEHICLE AND/OR THE
CRUISE CONTROL MODULE. MEASURE ONLY WITH THE ENGINE OFF.
Note: The CRUISE CABLE moves 41mm (1-5/8").
To measure throttle travel, measure the distance from Position "A" (Idle) to Position
"B" (Wide Open Throttle).
A. Make a mark on the throttle cable when the throttle is in the idle position.
B. Depress accelerator pedal and make a mark on the throttle cable when the
throttle is in the wide open position.
C. Measure the Distance "C" between the two marks. If the distance is greater than
41mm (1-5/8"), skip to step 3) ATTACHING CRUISE CABLE TO THROTTLE.
If the distance is less 41mm (1-5/8"), continue on to the next step, Step D.
D. If the throttle travel is less than 41mm (1-5/8"), you must add length to the
CRUISE CABLE to provide slack. – No more than 1/8".
NOTE: Slack is the distance the CRUISE CABLE moves before the throttle starts
to move. The less the slack, the better the operation. 1/8" maximum!
E. Slide a CONNECTOR COVER on the throttle LOOP CABLE and on the
CRUISE CABLE. Install a BEAD CHAIN CONNECTOR on the end of the LOOP
CABLE and on the end of the CRUISE CABLE. The BEAD CHAIN CONNECTOR
may need to be spread slightly for cable to enter.
- 7 -
650014B
Advertisement
Table of Contents
