SSS Siedle Access Professional V 5 Series Commissioning Instructions page 34

Setting up the Access system
Time profile
Configuration table "Actions for On/Off"
Function Explanation
Call rerouting Incoming calls are redirected to
another call destination on a device
on which call redirection is active.
Switching A switching function is triggered on
a device.
Send KNX A KNX telegram is sent from a device
Telegram (configured KNX gateway required).
Important: The effect of the KNX tel-
egrams in the KNX system depends
on the configuration of the KNX
system.
Story call Call signalling which is output on a
device or a group of devices when
triggered. A storey call is signalled for
approx. 5 seconds. To assign a group
to the storey call, a group must first
be configured.
34
Configuration
Important: If this function of another device is not
displayed, please check the permission settings.
• Call Redirection: Selection of the device on which this
function is to be executed
• Target: Device, group or external phone number to be
called during call redirection
• Type (type of call redirection):
- Immediately (all calls are redirected immediately)
- After time with the option "Immediately if busy" (all
calls are redirected with time delay; calls on busy are
redirected immediately)
- Redirect if busy (only calls on busy are redirected)
Recommendation: In addition, an status display should
be configured for this function.
Important: If this function of another device is not
displayed, please check the permission settings.
• Switch point: Selection of a device switching contact
for this function
• Value (type of execution):
- Toggle (change of function state: (ON becomes OFF /
OFF becomes ON)
- On (configured switching point is switched on)
- Off (configured switching point is switched off)
Recommendation: In addition, an status display should
be configured for this function.
• Gateway: Selection of the KNX gateway
• Group Address: Address of a KNX device that is to
receive the KNX telegram
• Feedback Object: Address via which the status of a
KNX device is to be reported back
• Value (type of execution):
- Toggle (change of function state: (ON becomes OFF /
OFF becomes ON)
- On (function is activated)
- Off (function is deactivated)
Important: If this function of another device is not dis-
played, please check the permission settings.
• Call Target: Select the device or group on which this
function is to be executed.
• Door opener: Selection of the door opener contact
that can be switched by the device.
• Door light: Selection of the door light contact that
can be switched by the device