LG SIGNATURE OLED65G7 Series Manual page 22

(Only OLED65/77W7T, OLED65/77W7V,
OLED65/77W7Y)
• The installation should be done by a qualified and
licensed electrician in accordance with wiring rules in
the Australian and New Zealand Standards AS/NZS 3000
for Electrical Installations. (Depending on country)
Provided item
Wall mount
Wall mounting screw
Ø5 x L65
Wall mounting screw for wood
Ø3 x L18
• Check the material of the wall and the thickness of the finishing.
• Use the Wall mount anchor for wall material of concrete, light
concrete, strong natural stone, soft natural stone masonry brick and
hallow block that do not crack.
Wall Material Tools
Concrete
Wall mounting
anchor, Wall
Brick
mounting screw,
Natural stone
Ø 3/6/8 mm
Drill bit
Metal Panel
Plywood
Wall mounting
EPS Panel screw, Ø 1.8 mm
Drill bit
Plasterboard + Plywood
• Do not mount the device on the walls made from plasterboard or
medium density fiberboard (MDF). In this case, the anchor and screws
must be inserted into the concrete behind the finish surface. If there
is no concrete on the other side, then you must first install a separate
hanger to securely install the anchors and screws.
• When installing the product on wall material not designated, install
the product so that each location can withstand the pull out load of
70 kgf (686 N) and shear load of 100 kgf (980 N) or above.
• Use the Ø 8 mm drill bit for concrete and hammer (Impact) drill.
Tools you will need
• Phillips head + driver (manual or motorized), Ø 3/6/8 mm Drill bit,
Level, Stud finder, Drill
10
How to attach to masonry walls
Please follow the below direction.
1 Use a drill bit Ø 8 mm to drill a hole for the anchor location within a
depth of 80 mm to 100 mm.
2 Clean the drilled hole.
Punching Guide
3 Insert the sealed wall mounting anchor to the hole. (When inserting
the anchor, use a hammer.)
Wall mounting anchor
4 Set the wall mount on the wall by aligning to the location of the
hole. And, set the angle adjusting part to face upward.
Wall Width
70 mm
5 Align the wall mounting screw to the hole and tighten it. Then,
30 mm
fasten the screws at torque of 45 kgf/cm to 60 kgf/cm.
Penetrate the wall
30 mm
Wall mounting anchor
Wall mount
Wall mounting screw