Telnet Setup; Modem Configuration - Tut Systems XL-12000S User Manual

FIELD
Subnet mask:
Default gateway:

7.2.3.5 Telnet Setup

Use the following procedure to initiate a Telnet session once the
initialization procedures described earlier in this section are complete.
Verify that a physical connection exists between the 10Base-T modem
port on the modem and a network device by pinging the LAN
address of the modem. Open a Telnet session using the IP address
of the modem that you set in the "LAN IP Address" field in the
"Modem Management" screen.
The user interface for a Telnet or serial connection is the same. The
first screen is the Login Display screen. Press <Enter> to proceed to
the Main Menu.

7.2.3.6 Modem Configuration

This section describes configuration options for the modem including:
• Master/Slave
• Modem Name
• Routing/Bridging Mode
• IP Addressing for both interfaces
• Static routing table entries
The values you will enter are dependent upon your pre-planned
network configuration.
Access to the Modem Configuration screen by pressing "C" from the
Main Menu.
7.0 CONFIGURE THE MODEM
MANAGED, HIGH-SPEED NETWORK MODEM USER GUIDE
DESCRIPTION
Enter the Subnet mask for IP address.
Enter the IP address of the default gateway to which
the modem LAN interface is connected.
XL-12000S
TUT SYSTEMS 35