Tut Systems XL-12000S User Manual page 24

XL-12000S
MANAGED, HIGH-SPEED NETWORK MODEM USER GUIDE
The configuration for the modems used in "Bridging Example One
(Basic Bridging)":
LAN IP addresses are shown in Figure 7.2 although this option does
not require you to enter new LAN IP addresses :
Note: If all administration and configuration of the modems is to be done via
the serial Console, as opposed to Telnet and SNMP sessions, no IP, mask, or
default gateway addresses need to be assigned to the modems.
For Modem 1:
The "LAN IP address" field in the Modem Management screen will
be set to 192.168.3.3
The "Subnet Mask" field in the Modem Management screen will be
set to 255.255.255.0
The "Default Gateway" field will be set to a valid default gateway.
The "Master/Slave" mode in the Modem Configuration screen is set
to Master.
The "Routing/Bridging" field in the Modem Configuration screen
will be set to bridging.
For Modem 2:
The "LAN IP address" field in the Modem Management screen will
be set to 192.168.3.2
The "Subnet Mask" field in the Modem Management screen will be
set to 255.255.255.0
The "Default Gateway" field will be set to a valid default gateway.
The "Master/Slave" mode in the Modem Configuration screen is set
to Slave.
The "Routing/Bridging" field in the Modem Configuration screen
will be set to bridging.
In order to Telnet or use SNMP to these modems, use the LAN inter-
faces. So, for example, the PC located in the Administration Building
will be able to Telnet to Modem 2's LAN interface. Likewise, the
Database Server will be able to Telnet to Modem 1.
16 TUT SYSTEMS
Back to Table of Contents
7.0 CONFIGURE THE MODEM