Configuring The Lsm - Neptune Systems Lunar Simulation Module Setup Manual

Table of Contents

Advertisement

CONFIGURING THE LSM

When the LSM is installed the Apex automatically creates 1 lunar LED control outlet (named
Lunar_X_1) that is be used to control the string of lunar LEDs. Depending on the version of
firmware installed on the Apex, the default program for the Lunar_X_1 will be one of these
two possibilities:
<Lunar_X_1>
Set OFF
If Moon 000/000 Then ON
Important note: If the default program does not contain a Set OFF statement, add the
Set OFF as shown above.
This one statement instructs the lunar simulator to turn on the LED lights on at the true
moon rise time and off at the moon set time. In addition, the intensity of the lunar lights is
adjusted daily so that they match the phase of the lunar cycle.
Lunar Simulation Module (LSM) - Setup Guide
Page 6

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Lunar Simulation Module and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents