1. Manuals
  2. Brands
  3. ASTRO Manuals
  4. Signal Processors
  5. U 100-230
  6. Operating manual

ASTRO U 100-230 Operating Manual

Base unit
Hide thumbs Also See for U 100-230:
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
Version 04-2014A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the U 100-230 and is the answer not in the manual?

Questions and answers

Related Manuals for ASTRO U 100-230

Summary of Contents for ASTRO U 100-230

  • Page 1 Version 04-2014A...

  • Page 2: Warranty Conditions

    The U 100 series is used to convert IP data streams into CATV signals. The base unit (U 100-230 or U 100-48) can accommodate up to three signal converters. The U 100-230 base unit can accommodate as well as up to two U 100-SNT power supply units for the U 1xx signal converters.
  • Page 3 Read carefully: EN 60728 -11 – Safety requirements / No service tasks during electrical storms!  To operate the device U 100-230 (protection class I), it must be connected to mains power sockets with a protective earth conductor. Assembly instructions...

  • Page 4: Device Description

    [7] Earth connection Figure 1: U 100 - base unit The base units U 100-230 and U 100-48 feature a CE marking. This confirms that the products conform to the relevant EC directives and adheres to the requirements specified therein.
  • Page 5 U 100 base unit, is correct, you must plug a corresponding jumper into the circuit board on the backplane. Proceed as described in the following. [1] Left slot [2] Middle slot [3] Right slot Figure 2: Coding the backplane by plugging in the bridge Operating manual U 100-230 and U 100-48 - Version 04-2014A Seite 5...
  • Page 6 The backplane is now connected and installed. Once installed, it should correspond to the figure at the left. HINWEIS You can learn how to connect a plug-in module to your PC or laptop by reading the operating manual for the respective signal converter. Seite 6 Operating manual U 100-230 and U 100-48 - Version 04-2014A...

  • Page 7: Troubleshooting

    U 100 is operating. Replacing power supply units After removing the screws from the cover of the power supply chamber (ASTRO logo), the power supply unit can be pulled forwards by hand using the mounting tab. When installing power supply units, do not touch the fan or fan grille and only use the mounting tab affixed to the power supply unit.
  • Page 8 Internet: www.astro-kom.de All the information contained in this document has been checked in good faith. The ASTRO company cannot be held liable for any damage or injury arising in connection with the use of these operating instructions. Operating manual U 100-230 and U 100-48 - Version 04-2014A...

This manual is also suitable for:

U 100-48

Table of Contents