Honda XL650V Owner's Manual page 104

03/06/03 13:00:18 32MCB600_104
Installation Notes:
1. To install the rear wheel, reverse the
removal procedure.
2. Make sure the tang ( ) on the swingarm
is located in the slot ( ) in the brake
panel ( ). 8
3. Install the rear axle shaft, side collar and
rear wheel to the swingarm.
4. Tighten the axle nut to the specified
torque:
88 N·m (9.0 kgf·m , 65 lbf·ft)
5. Adjust the drive chain.
When installing the wheel, carefully fit the
brake disc between the brake pads to avoid
damaging the pads.
After installing the wheel, apply the brake
several times and then check if the wheel
rotates freely. Recheck the wheel if the
brake drags or if the wheel does not rotate
freely.
94
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper assembly.
6 Improper assembly may lead to loss of
7 braking capacity.
(6) Tang
(7) Slot
(8)
(6)
(7)
(8) Brake panel