Craftsman 130.16491 Operator's Manual page 9

WARNING: Do not use this tool for scaffolding or as a ladder. Make sure to
tighten all locking knobs and levers securely prior to use. Maximum capacity is
330 lbs. Power tools on the stand should not exceed a combined overall height
of 60 inches from the floor.
SET UP THE STAND
1. Place the frame assembly with
legs (A) upside down on a flat
surface as shown in Fig. 2.
2. To open the top two legs, press
the locking pins and rotate the
legs until the locking pins snap
into the open position and you
hear a "click" to signal that the
legs are locked in place (Fig. 3).
3. Open and lock the other two
legs the same way.
4. Place the frame assembly on a
flat surface as shown in Fig. 4.
MOUNTING A MITER SAW
WARNING: Failure to unplug
the tool before attaching it to the
stand could result in accidental
starting and possibly serious
personal injury.
WARNING: To avoid serious
personal injury,always make sure
that miter saws are fully supported
and securely attached to a level
work surface. If necessary,move
the stand to a location where it will
be more stable.
WARNING: Do not mount
a table saw on this stand. The
direction of feed on a table saw is
perpendicular to the axis of stability
on this stand. Aggressive feeding
of sheet materials into a table saw
could cause the stand to tip over.
16491 Manual_Revised_18-0828
OPERATION
Fig. 2
Fig. 3
Press locking
pin to move leg
Fig. 4
A
A
M
Page 9