Table of Contents
Advertisement
Quick Links
User Manual and Parts
Book
Extreme Clean II
1200 - 1800
Serial number:
Translation of the original operating
instructions
ATTENTION:
IT IS OF THE UTMOST IMPORTANCE TO READ THIS USER MANUAL
CAREFULLY PRIOR TO USING THE EXTREME CLEAN II IN ORDER TO USE
THE MACHINE SAFELY AND TO OBTAIN THE BEST RESULTS.
1507 English 942.120.002
Kwekerijweg 8
3709JA Zeist
The Netherlands
T: (31)306933227
F: (31)306933228
E: verti-drain@redexim.com
www.redexim.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Redexim Extreme Clean II 1200
Summary of Contents for Redexim Extreme Clean II 1200
-
Page 1: User Manual And Parts Book
Extreme Clean II Kwekerijweg 8 3709JA Zeist The Netherlands 1200 - 1800 T: (31)306933227 F: (31)306933228 E: verti-drain@redexim.com www.redexim.com Serial number: Translation of the original operating instructions ATTENTION: IT IS OF THE UTMOST IMPORTANCE TO READ THIS USER MANUAL CAREFULLY PRIOR TO USING THE EXTREME CLEAN II IN ORDER TO USE THE MACHINE SAFELY AND TO OBTAIN THE BEST RESULTS. -
Page 2: Warranty Conditions
FOREWORD Congratulation on your Extreme Clean II purchase! For safe and long-lasting operation of the Extreme Clean II, it is necessary to read and to understand this user manual. It is impossible to work safely with this machine without complete knowledge of its content. The Extreme Clean II is not a machine that works independently. -
Page 3: Safety Instructions
SAFETY INSTRUCTIONS The Extreme Clean II is designed for safe use. This can only be achieved if you completely follow the safety instructions described in this manual. Read and understand the manual before (Figure 1) you start using the Extreme Clean II. If the machine is not used as described in this manual, this can result in injuries and/or damage Figure 1... - Page 4 If modifications to the Extreme Clean II have been made, then the current CE marking is cancelled. The person that has made these modifications has to apply for a new CE marking himself. Check the Extreme Clean II for loose bolts, nuts and components before every operation.
- Page 5 Only authorised technical personnel may carry out repairs to the Extreme Clean II. Keep a record of the repair activities. 5. The general applicable health & safety (Dutch: ARBO) regulations must also be followed in addition to the instructions in this user manual. Relevant traffic regulations also apply in case of using public roads.
- Page 6 Pay attention to the permitted lifting capacity of the towing vehicle. Dress appropriately. Wear sturdy shoes with steel toecaps, long trousers and tie up long hair. Do not wear loose clothing. Figure 5 Location of the safety stickers (Figure 5)
-
Page 7: Eu-Declaration
EU-DECLARATION Redexim BV Utrechtseweg 127 3702 AC Zeist, the Netherlands declare entirely under our own responsibility that the product: OVERSEEDER WITH MACHINE NUMBER AS STATED ON THE MACHINE AND IN THIS MANUAL, to which this statement relates, is in accordance with the provisions of the Machine Directive 2006/42/EG. -
Page 8: Table Of Contents
TABLE OF CONTENTS USER MANUAL AND PARTS BOOK ............... 1 WARRANTY CONDITIONS ..................2 REGISTRATION CARD ..................... 2 !SAFETY INSTRUCTIONS! ..................3 EU-DECLARATION ....................7 TECHNICAL DATA ..................9 FIRST INSTALLATION – TAKING THE MACHINE OFF THE PALLET ..10 ... -
Page 9: Technical Data
TECHNICAL DATA Model 1200 1800 Working width 1.20 m (47”) 1.80 m (71”) Working depth Adjustable Adjustable Speed Maximum 12 km/h (7.5 Maximum 12 km/h (7.5 mph) mph) Weight 242 Kg (534 lbs) 317 Kg (699 lbs) Recommended tractor 18 HP 18 HP Minimum lift capacity of 250 kg (441 lbs) -
Page 10: First Installation - Taking The Machine Off The Pallet
FIRST INSTALLATION – TAKING THE MACHINE OFF THE PALLET Figure 6 The machine is placed vertically on the pallet. To remove the pallet and to place the machine horizontally on the ground, you take the following steps (see Figure 6) !! NEVER CRAWL UNDER THE MACHINE! 1. -
Page 11: The Power Take-Off (Pto)
THE POWER TAKE-OFF (PTO) The PTO is a very important component. It takes care of the drive of the tractor and of a safe use of the machine, provided it is installed and maintained in the correct manner. The PTO has its own CE certification. -
Page 12: Use Of The Pto
USE OF THE PTO The following items must be checked for correct use of the PTO: 1. While working the angle of the pivot pins may not exceed 30 degrees. 2. The pivot pins must always be aligned. 3. The overlap of the cylinders must always be minimum 150 mm. 4. -
Page 13: Adjusting The Forcefulness Of The Machine
6. Connect the top rod (3) to the frame with the pin (1); secure the pin (1) with the supplied locking pin. 7. Turn the top rod (3) inwards so that it becomes pressurized. !! Make sure that all the securing pins are locked! 8. -
Page 14: Start/Stop Procedure
START/STOP PROCEDURE The start procedure is VERY important. If this procedure is not executed as described below, it might result in serious damage to the subsoil. The start procedure is as follows: 1. Check the Extreme Clean II for loose components and look whether all components function properly. -
Page 15: Detaching The Extreme Clean Ii
10.0 DETACHING THE EXTREME CLEAN II Figure 9 The machine can be detached from the tractor in the following manner (See Figure 9) 1. Drive the Extreme Clean II to a parking area with a firm/flat surface. !! Make sure that the tractor is blocked well and cannot move on its own accord! !! Switch off the tractor before descending! 2. -
Page 16: Trouble Shooting (Problem Analysis)
11.0 TROUBLE SHOOTING (PROBLEM ANALYSIS) Problem Possible cause Solution Too little decompaction Working depth is Adjust the machine to adjusted too shallow more depth Subsoil is too hard Drive slower Adjust the working depth to less depth and continue to work again. Brushes not turning more Drive is faulty Check the driveline... -
Page 17: Grease Points
12.1 Grease points Grease all bearings... -
Page 18: Adjusting The Tension Of Chains
13.0 ADJUSTING THE TENSION OF CHAINS The Extreme Clean II is standard equipped with adjustable chain wheels. Depending on the intensity of using the machine, the driveline could be affected by wear and tear. The chain should then be tightened. Fig. -
Page 19: Rotating The Gearbox
14.0 ROTATING THE GEARBOX Over time the bristles will put itself in one direction. The work image will appear less. It is then possible to change the direction of rotation of the brushes by turning the gearbox . Fig. 11 !! Make sure that the tractor is blocked well and cannot move on its own accord! !! Switch off the tractor before descending! 1.
Need help?
Do you have a question about the Extreme Clean II 1200 and is the answer not in the manual?
Questions and answers