RIDGID OF50150TS Replacement Instructions

OF50150TS AIR FILTER REPLACEMENT INSTRUCTIONS
Installing the High Flow Filter
See Figures 1 - 2.
 Turn the air compressor off and disconnect it from the
power supply.
 Remove the easy start filter and adaptor by turning
counterclockwise.
NOTE: Use a 1 in. box wrench if needed.
 Insert the high flow filter into the air inlet opening.
NOTE: Do not use thread seal tape.
 Turn clockwise to tighten.
Fig. 1
REMOVE THE EASY START FILTER
Fig. 2
INSTALL THE HIGH FLOW FILTER
Installing the Easy Start Filter
See Figures 3 - 5.
 Turn the air compressor off and disconnect it from the
power supply.
 Remove the high flow filter by turning it counterclock-
wise.
NOTE: Use a 23 mm box wrench if needed.
 If the adaptor is not installed on the easy start filter,
install the adaptor and tighten.
NOTE: Do not use thread seal tape.
 Insert the easy start filter and adaptor into the air inlet
opening.
 Turn clockwise to tighten.
Fig. 3
REMOVE THE HIGH FLOW FILTER
Fig. 4
INSTALL THE ADAPTOR
Fig. 5
INSTALL THE EASY START FILTER