Table of Contents
Advertisement
1
General Truck/Trailer Requirements
The illustrations below describe the factory-approved methods of mounting a Princeton
PIGGYBACK
This section covers the general setup information on the PIGGYBACK
NOTE: This information is necessarily general and is based on similar applications. Contact
Princeton and fill out a Mounting Application Form to assure your specific transport vehicle
application meets the requirements for installation of a Princeton PIGGYBACK
Dimensions
Axle Location
Bed Height
to a transport vehicle (Truck or Trailer).
®
Figure 1
Axles must be located as far to rear as possible while leaving clearance
for the PIGGYBACK
of 33" to maximum of 48" are acceptable. In some instances, special
consideration can be given for some applicable forklift models.
The PIGGYBACK
with the ground when driving onto steep inclines, ramps, etc. The
minimum distance from the ground to the bottom of the truck or trailer
crossmember is 48". The minimum recommended distance tire
clearances, with an unladen/level transport vehicle, is 11" front & 18" rear
to ground.
front tires. As a requirement, minimum dimensions
®
must be installed as high as possible to avoid contact
®
and transport vehicle.
®
.
®
Hide quick links:
Advertisement
Table of Contents
