Table of Contents
Advertisement
5
Main Installation
Transverse Tube Install (Cont.)
Hanger Plate Installation
In special instances, where there is a conveyor or boom
mechanism, that extends beyond the rear sill of a transport
vehicle, a 'low fork tine setup' may be necessary. The minimum
distance of the rear transverse tube, from the top surface to level
ground should be set between 18" to 22". Check for any
obstructions, before proceeding with final welding.
Cut notches in c-channel at rear of bed as shown in Figure 3.
Clean weld area.
Figure 3
Measure centerlines of the truck or trailer bed crossmembers.
Install P90.292A (1/2 " x 3" x 3") Plates in the P90.1067C Hanger
Plate Weldments at each crossmember dimensional centerline as
shown in Figure 4 and Figure 5. Tack weld in place.
Figure 4
Figure 5
Hide quick links:
Advertisement
Table of Contents
