Mount Installation Check - Princeton PIGGYBACK EZ HITCH Installation Instructions Manual

Truck/trailer mounting
Table of Contents

Advertisement

13

Mount Installation Check

1.) Check that the front tire pressures are correct, per the rating on the tire sidewall.
2.) Position both tire pads, per the particular forklift model. Check that the Pin Bolt Nuts are tight and
that the Lynch Pins are in their locked position.
3.) Check that the 4x mounting bolts on both Track Weldments are torqued properly.
4.) Mount the forklift on the transport vehicle.
5.) Depress the Lower-N-Go button on the left rear side of the forklift. (Earlier models you'll need to
install the 7-Pin Harness and activate the right turn signal in the transport vehicle).
6.) Check that there is approximately 3/4-1" of tire compression.
7.) Ensure that both Hitch Pins can be freely (With the forklift relaxed and front tires resting against
tire pads) inserted and removed. Check that both Lynch Pins on the Hitch Pins are in their locked
position.
8.) Check that both Sling Hooks can be installed and removed easily in the Chain Loops or to the
frame. When the Sling Hooks are installed, the safety chains should be slack.
9.) Check that both ends of the 7-Pin connector can be installed and removed easily.
4
7
5
3
2
8
6
1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents