Before Using Your Kettle; Using Your Electric Kettle - BonsenKitchen EK8902 Operation Instructions Manual

BEFORE USING YOUR KETTLE

If you are using the kettle for the first time, it is recommended that you should
clean your kettle before use by boiling a full kettle of water twice and then
discarding the water.
NOTE: The max capacity of kettle is 1.7L.

USING YOUR ELECTRIC KETTLE

1. Place the unit on the level surface.
2. To fill the kettle, remove it from the power base and open the lid by pressing
lid release button, fill with the desired amount of water, and then close the lid.
Alternatively, the kettle may be filled through the spout. The water level should
not exceed MAX marks or sit below MIN level. Too little water will result in the
kettle switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the
spout when boiling.
Ensure that the lid is firmly in place before plugging the power outlet.
3.
Position the kettle on the power base.
4.
Connect the plug into a power outlet.
NOTE: When the power is turned on or water temperature reaches the set
temperature, 2 beeps will be heard.
When button is operated each time, one beep will be heard.
HEATING /OPERATION
Operation mode 1 :
1. Press button to select 104, 131, 158, 185 °F temperature for heating
water, when selecting temperature, the corresponding blue light is always on.
2. Then press the
left and right water gauges of the kettle is on and the kettle starts to heat up.
3. When water temperature reaches the set value, the indicator light at the water
gauge is off and kettle stops heating.
4. If no operation within 60S, the blue temperature indicator is off.
button to confirm, the corresponding indicator light on the
4