Pro-face AGP3000 Quick Start Manual

Pro-face AGP/AST3000 to Yaskawa J7
Drive via Modbus RTU
Pro-face AGP3300-T1
HMI Motion Quick Start Guides
Pro-face HMI motion control quick start guides make it easy to integrate variable speed
drives directly to your operator interface and control system. With minimal knowledge
a user can quickly set up a variable speed drive operator interface without requiring a
separate programmable controller and drive interface wiring.
Differentiating Value:
• Simple, fast installation, 3 step guide with a sample project you can use
• No PLC required, logic controller is built-in
• Reduce system cost, no need for analog interfaces, eliminate pilot
lights and push buttons
• Precision high resolution digital control
Applications:
• Conveyors
• Pumps and fans
• Packaging equipment
• Discrete manufacturing
These instructions along with the downloadable sample project facilitate quickly
connecting and establishing communications between a Pro-face AGP using GP-Pro EX
and a Yaskawa J7 Drive. For a full explanation of this project refer to Pro-face America
Application Note 1157.
Materials:
1. Pro-face GP-Pro EX Screen and Logic Editing software v2.1 or higher
2. Pro-face AGP3000 or AST3000 Series HMI
3. Yaskawa J7 Drive
4. Yaskawa SI-485/J7 Modbus RS485 Adapter
5. Pro-face CA4-ADPONL-01 COM2 Port Adapter
6. Pro-face CA3-ADPTRM-01 Termination Adapter
7. 5-Wire Shielded Cable
8. The Pro-face sample project "APNT1157.zip"
available at: https://www.hmisource.com/otasuke/files/appnotes/
Right Size, Right Technology Solutions
Tested, Trusted, Out-of-the-Box
Modbus
Serial Cable
Yaskawa
J7 Drive
5.7"
3.8"
Continued on next page
12.1"
10.4"
7.5"
AGP3000 Operator Interfaces
15"
®