Troy-Bilt Wide-Cut 753B Operator's Manual page 12

Section 3: Features and Controls
Engine Throttle Control
This lever (G, Figure 3-6) is used to
adjust engine speeds and, on non-
Electric Start models, to stop the engine.
Always run engine at fast speed setting
for best mower performance. The throt-
tle settings are shown below.
CHOKE - Use when
starting a cold engine.
FAST - Use during mower
operation.
SLOW - Use when idling
engine.
STOP - Stops engine
(Non-electric Start Models
Only)
Ignition/Starter Switch -
(Electric Start Model)
This three-position switch (H, Figure
3-6) is used to start and stop the
engine on electric start models. The ig-
nition key settings are shown below. Do
not turn the key until you have read the
Operation Section in this Manual.
Always remove ignition key when
leaving mower unattended or when in-
specting, cleaning or servicing mower.
STOP - Stops engine.
RUN - After starting, key
returns to run position.
START - Starts engine.
Release key when engine
starts.
10
H – IGNITION/STARTER
SWITCH
Figure 3-6
Engine Recoil Starter
The recoil starter (I, Figure 3-7) is
used to "pull-start" the engine. Detailed
instructions for using the recoil starter
are found in the Operation Section of this
Manual and in the Engine Owner's
Manual. Do not pull the recoil starter
until you have read the Operation
Section.
I – RECOIL
STARTER
Figure 3-7
G – THROTTLE CONTROL