Additional Powerline Adapters - Swisscom Powerline Setup Manual

Additional Powerline adapters

You can connect additional Powerline adapters (optional). In order to do so, your existing Pow-
erline adapters must be on . If one of them is in energy saving mode, unplug it and replug it
again. Wait until the green light turns on.
1
Plug the Powerline adapter into a power socket at the desired location.
2
Press approx. 15 seconds the Pairing button of your new Powerline adapter, until all
LEDs (« », «
New
adapter
3
Press approx. half a second the Pairing button of one of your already existing Powerline
adapters.
1st or 2nd
adapter
4
Press approx. half a second the Pairing button of your new Powerline adapter.
New
adapter
5
Connect the Ethernet cable included in the package to your device.
(« », « » and «
Note: you can connect additional Powerline adapters from Swisscom by proceeding exactly
this way.
4
» und « ») light up in orange.
Press until all LEDs light up
After a short while the LED indicating that your new adapter is in
service « » will light up in green.
Press half a second then release
The service LED «
Note: if it's not blinking, repeat this step.
Press half a second then release
The service LED «
After a few seconds « » and «
Note: if it's not blinking, repeat this step.
» light up in green. If the device is not on, «
» will start blinking in green.
» will start blinking in green.
» light up in green.
» does not light up.)
English