Installation - Prem-I-Air EH1462 Manual

IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the product
for future reference.

INSTALLATION

To wall-mount:
This unit should be mounted at least 60 cm below any ceiling and must have
30 cm clearance on each side. Flammable items, for example patio umbrellas,
should be no closer than 150 cm from the front grille.
When the correct mounting point has been established draw two horizontal lines
on the wall 90 mm (3½") apart, the lower line more than 1500 mm (5') from the
floor. Mark a centre line vertically down across both lines (fig.1).
On the upper line, drill holes 130 mm (approx. 5¼") from the centre line on each
side, using a 6 mm (¼") masonry bit, and insert a wall plug.
On the lower line repeat the actions marking and drilling 2 holes and inserting the
correct wall plugs (fig.2).
Insert screws into the lower two holes and tighten to 3 mm from the wall (fig.3).
Hang the heater on the lower screws using the keyhole slots on the back (fig.4).
Insert screws through the upper 2 holes in the heater bracket and tighten fully
(fig.5&6).
The desired angle can be set using the 2 pivot screws on the bracket. These
should be fully tightened and checked before the unit is switched on.
1. 2.
2
2837 Ver. 1 - 04/14