Installation - Prem-I-Air EH0368 Manual

IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the product
for future reference.

INSTALLATION

To wall-mount: Referring to the diagram below, draw two horizontal lines on the
wall 90 mm (3½") apart, the lower line more than 1500 mm (5') from the floor.
On the upper line, drill holes 70mm (2¾") from the centre line, using a 6 mm (¼")
masonry bit, and insert a wall plug.
On the lower line, drill a hole on centre line using a 6 mm (¼") masonry bit, and
insert a wall-plug.
Insert screws into the upper two holes and almost fully tighten.
Hang the heater on the upper screws using the keyhole slots on the back.
Insert a screw through the hole in the heater, just below the power display
window. This screw will fit into the lower hole.
Fully tighten the screw, and push the rubber plug (supplied) into the hole to
protect from water ingress.
2