Pairing Your Headphones; Active Noise Cancellation; Monitor Mode - SOL Republic Soundtrack Pro Instruction Booklet

SETUP

PAIRING YOUR HEADPHONES

6 EN
CHARGING HEADPHONES
To charge your Soundtrack Pro, plug
the charging cable into the port on
the right side of your headphones.
LED INDICATION
While charging, the large LED light
will be red. A full charge will take
approximately 3.5 hours. When fully
charged, the large LED light will
be blue.
STEP ONE
To pair your headphones, make sure
the Bluetooth setting on your
®
mobile device is turned on.
STEP TWO
Turn on your headphones by
pressing and holding the power
button for 3 seconds. The power
button is located on the bottom of
the headphone on the right side.
The large LED will flash red and blue
when searching for a device.
STEP THREE
Select "Soundtrack Pro ANC" from
the Bluetooth list on your mobile
®
device. Once the headphones are
connected, the large LED light will
pulse blue.
UNPAIR YOUR HEADPHONES

ACTIVE NOISE CANCELLATION

Note: ANC will not work when powered off

MONITOR MODE

STEP ONE
To unpair your headphones, press
the center multi-function button on
top of the neckband on the left side
for 5 seconds. You will hear a voice
prompt stating the headphones are
ready to pair.
ENABLE OR DISABLE
ANC MODE
With power on, press power button
once for ANC. To disable ANC, press
power button once again.
ENABLE OR DISABLE
MONITOR MODE
Quick press power button twice for
Monitor Mode. To disable Monitor
Mode, quick press twice again.
EN 7